This guide follows RetroDECK's Linux-oriented setup for its managed Dolphin emulator. It covers two methods: the emulated Bluetooth adapter method for official Wii Remotes and Bluetooth passthrough, which the documentation describes as supporting official and third-party Wii Remotes. That is not a guarantee for every controller or adapter.

Before you start

  • - A Wii Sensor Bar alternative, wired or wireless.
  • - A Linux-compatible Bluetooth dongle or built-in Bluetooth adapter.
  • - For the first method, an official Wii Remote.

Method 1: Emulated Bluetooth adapter

  • 1. Open RetroDECK Configurator → Open Emulator → Dolphin → Options → Controller Settings.
  • 2. Under “Emulate the Wii's Bluetooth adapter,” change the Wii Remote dropdowns from “Emulated Wii Remote” to “Real Wii Remote.”
  • 3. Enable “Connect Wii Remotes for Emulated Controllers” and “Continuous Scanning.”
  • 4. Launch a game and press the Wii Remote's Sync button to connect.

Reconnect the remote whenever you launch a new game. The documentation says that, when this setup is working, pressing A should allow quick reconnection without pressing Sync again.

Method 2: Bluetooth passthrough

Open a terminal and run lsusb to identify your Bluetooth adapter. In its ID pair, the value before the colon is the vendor ID and the value after it is the product ID. For example, 8087:0025 means vendor ID 8087 and product ID 0025; use your own adapter's values.

Add the documented USB access rule to /etc/udev/rules.d/52-dolphin.rules. Replace “Vendor ID” and “Product ID” in the command with the values you identified before running it.

TEXT
sudo echo 'SUBSYSTEM=="usb", ATTRS{idVendor}=="Vendor ID", ATTRS{idProduct}=="Product ID", TAG+="uaccess"' | sudo tee -a /etc/udev/rules.d/52-dolphin.rules > /dev/null

Reload the rules with the following command, then unplug and reinsert the Bluetooth adapter. If you are using a built-in adapter, reboot instead.

TEXT
sudo udevadm control --reload-rules
  • 1. Return to RetroDECK Configurator → Open Emulator → Dolphin → Options → Controller Settings.
  • 2. Change “Emulate the Wii's Bluetooth adapter” to “Passthrough a Bluetooth Adapter.”
  • 3. Follow the documented checkbox settings: “Connect Wii Remotes for Emulated Controllers” and “Continuous Scanning.”
  • 4. Launch a game, then press 1 and 2 together on the remote, or press its Sync button under the backplate.
  • 5. Reconnect when launching each new game.

Sync and reconnection

If pairing needs the emulated Wii's Sync button, use that button in Dolphin's interface. RetroDECK also provides Alt + W for Dolphin's “Sync Wiimote” action, with access through some Steam Input radial menus. This is the documented shortcut to try after a Steam Input disconnection.

Evidence and publication details

Sources & references

Content responsibility: FrameTinker editorial desk. Source authors and software maintainers are credited separately below; this is not a claim of hands-on testing.

Published .

RetroDECK: wiki emulator guides — dolphin — dolphin wii remote — official gaming software documentation https://raw.githubusercontent.com/RetroDECK/Wiki/main/wiki-rtd/docs/wiki_emulator_guides/dolphin/dolphin-wii-remote.mdRetrieved Nov 14, 2026

Something doesn’t match your setup?

Suggest a correction